Reflection Protection™ - Specialty Materials

fabrics

RF-9501 – Nylon and other heat-sensitive fabrics

RF-9505 – Cotton and cotton-blended fabrics

sizing

Available Widths (in.): 19” only
Available Lengths (ft.): 15’, 30’, 45’, 60’, 75’, 90’, & 162’ rolls

thickness

5.6 mils/140 microns

• Used for nighttime visibility
• Gives a max reflectivity of 675 candelas/lux/square meter
• Certified safety reflective colors
• Made with very small glass beads in a layer of polyester film

Use Reflection Protection™ for nighttime visibility and brilliance in the spotlight!

Reflection Protection™ films consist of very small glass beads embedded in a layer of polyester film to reflect almost all the light that shines on them.

Reflection Protection™ is available in Certified Safety Reflective Colors, our Safety Silver collection. Safety Silver retro-reflective film produces a maximum reflectivity of 675 candela/lux/meter. This product does not have a sticky carrier.

Use Safety Silver for garments and other products used by police, firefighters, EMS, postal workers, traffic control, parking, utility, road, construction, security personnel, runners, bicyclists and motorbikers, among others.

LASER compatible

Application Instructions

IT’S BEST TO TEST!

If you’re using this product for the first time or trying a new garment, it’s always best to test on an inconspicuous area or spare garment before applying final production.

BLADE – 60°, slow cutting speed

CUT ORIENTATION – Mirror image

TEMP – 9501 – 320° F
9505 – 250-275° F

PRESSURE – Firm, even

TIME – Prepress garment for 5 seconds, then press material for 3-5 seconds

PEEL – Warm for 9501 and Cold for 9505, cover with Teflon and repress for 10-15 seconds, let cool then remove Teflon

CARE – Wash inside out. Warm water, gentle cycle. Tumble dry low heat. Dry-cleaning ok.

LAYERABLE? – Top layer only

Tech Info

Tech PDF includes product thickness, roll sizing, and other technical information

Safety Silver for Nylon

Safety Silver for Cotton

Cut Settings

PLEASE NOTE: Every blade and machine is a little bit different- always remember to test cut! These cut settings are a starting point to be adjusted to your blade and machine.