ThermoFlex® Xtra

Chose ThermoFlex ® Xtra for application to nylon, leather, and other heat sensitive fabrics. It uses a hot-melt adhesive that activates at a lower temperature than ThermoFlex® Plus

► Create your design in graphics software, such as Corel Draw and mirror the image in the effects menu.

► Load ThermoFlex® Xtra onto your plotter.

Always test cut to ensure proper depth, speed and down force.

Cut in mirror image.

Weed film from carrier that you do not want to transfer.

Place image on the surface to which you are transferring the film

Place a Teflon sheet between the heat platen and the polyester carrier sheet to prevent sticking and edge damage of the transferred design.

► Heat press between 300° F - 315° F for 3 - 5 seconds using firm even pressure.

► Let cool before removing the carrier sheet. Peel cool.

► Cover transferred image with Teflon release sheet and reheat 10 seconds to complete cure.

► If ThermoFlex® Xtra only partially adheres to the fabric it is usually because insufficient or uneven pressure was applied. If this happens, reposition the design, increase the pressure and repress.

► Follow wash instructions for nylon. Turn inside-out, cold water, tumble dry low heat.

 

All technical information and recommendations are based on tests we believe to be reliable. We cannot guarantee performance, however, for conditions not under our control. Before using, please read our product descriptions and instructions to determine the suitability of each product for your intended use. The user assumes all risk and liability in connection with their use.

Print This Page