Use on open mesh polyester athletic jersey.

Choose ThermoFlex® Sport for use with open mesh polyester athletic jersey. It's thicker properties bridge the openings in the mesh for a smoother finish.

► Create your design in graphics software, such as Corel Draw and mirror the image in the effects menu.

► Load ThermoFlex® Sport onto your plotter.

Always test cut to ensure proper depth, speed and down force.

Cut in mirror image.

Weed film from carrier that you do not want to transfer.

Place image on the surface to which you are transferring the film

Place a Teflon sheet between the heat platen and the polyester carrier sheet to prevent sticking and edge damage of the transferred design.

► Heat press between 300° F- 320° F for 8 - 10 seconds using firm even pressure.

►If ThermoFlex® Sport only partially adheres to the fabric it is usually because insufficient or uneven pressure was applied. If this happens, reposition the design, increase the pressure and repress.

► Peel warm or cold. It is much easier to peel when still warm but for consistent results allow at least 10 seconds of cooling time before peeling.

► Wash at normal settings.

► Will adhere to most fabrics. Use the lower temperature and shorter dwell time when applying to Nylon.

 

All technical information and recommendations are based on tests we believe to be reliable. We cannot guarantee performance, however, for conditions not under our control. Before using, please read our product descriptions and instructions to determine the suitability of each product for your intended use. The user assumes all risk and liability in connection with their use.

Print This Page