For outdoor durable banners, flexible signs, vinyl tire covers, plastic coated awnings and coated architectural fabrics

► Create your design in graphics software, such as Corel Draw and mirror the image in the effects menu.

► Load ThermoBanner™ onto your plotter.

Always test cut to ensure proper depth, speed and down force. ThermoBanner™ is a relatively thick material and requires a different cutting procedure than other Specialty Materials films for optimum cutting and weeding . Reduce the cutting speed and adjust the blade depth to produce accurate cutting. Using a 60° blade can also improve cutting. If slipping or buckling occurs, apply application tape along the edges on the bottom side of the material to increase thickness between the pressure rollers.

Cut in mirror image.

Weed film from carrier that you do not want to transfer.

Place image on the surface to which you are transferring the film

Place a Teflon sheet between the heat platen and the polyester carrier sheet to prevent sticking and edge damage of the transferred design.

► Heat press between 212° F - 284° F for 10 - 15 seconds with medium pressure.

► You can also apply ThermoBanner™ with a hand held iron or heat gun. ThermoBanner™ requires a medium amount of pressure to insure adhesion. If you are attempting to apply with an iron or heat gun, assistance will be needed. After one person applies sufficient heat to activate the film's hot-melt adhesive, the other person should immediately place pressure on the film with a towel.

► Let cool completely before removing carrier sheet. Peel cold.

Please remember: This is a thicker material so it is especially important to perform test cuts before final plotter cutting of your image.

 

All technical information and recommendations are based on tests we believe to be reliable. We cannot guarantee performance, however, for conditions not under our control. Before using, please read our product descriptions and instructions to determine the suitability of each product for your intended use. The user assumes all risk and liability in connection with their use.

Print This Page