Thin metallic foils.

Use DecoFilm™ when your design calls for a bright metallic finish

► Create your design in graphics software, such as Corel Draw and mirror the image in the effects menu.

► Load DecoFilm™ onto your plotter.

Always test cut to ensure proper depth, speed and down force.

Cut in mirror image.

Weed film from carrier that you do not want to transfer.

Place image on the surface to which you are transferring the film

Place a Teflon sheet between the heat platen and the polyester carrier sheet to prevent sticking and edge damage to the transferred design.

► Heat press between 310° F - 330° F for 10 - 15 seconds using firm even pressure.

► If DecoFilm™ only partially adheres to the fabric it is usually because insufficient or uneven pressure was applied. If this happens, reposition the design, increase the pressure and repress.

► Cool completely. Peel cold.

► Remove the Mylar carrier sheet carefully. The colors on the metal foil have a tendency to peel with the backing if too much heat or dwell time is applied or the design is not completely cooled when peeled.

► Cover and reheat if necessary.

► Wash inside-out, cold water, gentle cycle, dry low heat.

► Adheres to most fabrics.

This decorative material should be handled with care. Metallic foils will not have the stretch and rebound characteristics of some of our other heat applied materials and are not appropriate for certain applications. Discretion should be used regarding the intended use of the garment.

 

All technical information and recommendations are based on tests we believe to be reliable. We cannot guarantee performance, however, for conditions not under our control. Before using, please read our product descriptions and instructions to determine the suitability of each product for your intended use. The user assumes all risk and liability in connection with their use.

Print This Page